Step 1.
Core a 10-12" diameter hole the depth of the pavement and auger out debris until core depth is achieved. We recommend at least an 18" core. |
Step 2.
Assemble 3 piece Goal Post unit on ground by removing end caps and drawing out set screw approximately 1/2 way. Then place our steel floor sleeve into the cored hole, plumb, and set the steel floor sleeve with concrete.
|
Step 3.
After the concrete sets, insert the Goal Post into the steel floor sleeve. This will add strength and make it removable. |
Step 1.
Core a 10-12" diameter hole the depth of the pavement and auger out debris until core depth is achieved. We recommend at least an 18" core.
|
Step 2.
Assemble 3 piece Goal Post unit on ground by removing end caps and drawing out set screw approximately 1/2 way.
|
Step 3.
Hoist up with forklift, plumb, set, and brace. Once cement cures remove brace.
|
